Annual Backflow Testing
The purpose of annual backflow testing is to assure the performance of backflow prevention assemblies which prevent the occurrence of cross contamination with the water supply or within a plumbing system. Assemblies can be found on potable water supplies, fire lines, irrigation systems, and internal equipment feeds. The testing is required by the NYS Department of Health code section 5-1.31 and enforced by the local water purveyor.
Installation of Backflow Assemblies
As required by state code, all new construction requires the installation of backflow prevention assemblies. You may also be asked to install an assembly on an existing water main to bring a premise up to code. We can provide a free estimate to correctly install your assembly and guarantee compliance with current water purveyor requirements.
Backflow Assembly Repairs
Backflow assemblies are mechanical devices with moving parts which can fail or break down with wear, non-use and/or time. We stock a large selection of parts to repair, rebuild or replace an assembly that is defective. Whatever we don’t carry we can usually get within 24 hours from our suppliers.
Portable Assembly Testing
We have a test bench within our facility to test portable assemblies required for obtaining hydrant permits. Our shop is conveniently located at 106 Railroad Avenue in Sayville. Just drop off your assembly and it will be tested, certified and ready for pick up within 24-48 hours. We can provide any minor repairs necessary at the time of testing.
Efficient
Accurate
Professional
